BT Internet Radio: Difference between revisions
Jump to navigation
Jump to search
(BT Internet Radio details) |
|||
(4 intermediate revisions by the same user not shown) | |||
Line 32: | Line 32: | ||
==Firmware== | |||
'''v255-c-194''' - circa 2006 | |||
No official upgrades available as of April 2010. | |||
==User Manual== | ==User Manual== | ||
http://www.shop.bt.com/content/uni2/documentation/4bdq/028983.pdf | http://www.shop.bt.com/content/uni2/documentation/4bdq/028983.pdf | ||
==Power Supply Unit== | |||
Supplied with a 7.5V @ 1.1A switched mode mains power adapter. DC power plug specifications are: 5.5mm diameter/2.1mm inner diameter/12mm long barrel, centre positive polarity. If you are sourcing a replacement, note that a short 9mm length plug will NOT fit this radio properly. | |||
==How to add remote control to the BT Internet Radio== | |||
http://logikir100.tripod.com/irmod.htm |
Latest revision as of 15:15, 14 May 2010
Introduction
This radio first appeared in late 2006.
Pictures
Photos reproduced with the permission of Logikir100.tripod.com
Opening the BT Internet Radio
This is one of the easier radios to open.
- Remove the 4 recessed screws from the back of the case.
- Turn the radio upside down and carefully separate the two halves of the case by no more than 1 to 2 inches.
- Look inside and you will see 3 red/black cables near the bottom of the case. Carefully detach them from the main circuit board.
- You can now fully open up radio.
Firmware
v255-c-194 - circa 2006
No official upgrades available as of April 2010.
User Manual
http://www.shop.bt.com/content/uni2/documentation/4bdq/028983.pdf
Power Supply Unit
Supplied with a 7.5V @ 1.1A switched mode mains power adapter. DC power plug specifications are: 5.5mm diameter/2.1mm inner diameter/12mm long barrel, centre positive polarity. If you are sourcing a replacement, note that a short 9mm length plug will NOT fit this radio properly.